Planning a ramp for a front door or porch can feel like a math test you didn’t study for. The good news is that figuring out the right wheelchair ramp length comes down to one measurement and one simple rule.
The standard guidance from the ADA is a 1:12 slope. That means for every 1 inch of rise, you need 12 inches of ramp. So a 6-inch step needs a ramp about 6 feet long, and a 24-inch porch needs one about 24 feet long. Here’s how to measure and plan it properly.
What the 1:12 slope rule means
The ratio compares how high you’re climbing (the rise) to how far the ramp stretches along the ground (the run). A 1:12 slope is the steepest ADA guidance allows for a typical public ramp, and it’s a good target for a home too.
Steeper ramps are harder to push up and can feel unsafe going down, especially for someone self-propelling a manual chair. A gentler slope is easier for everyone, so treat 1:12 as the steepest you’d plan for. If space makes that hard, an occupational therapist or a qualified installer can help you find a safe plan.
Keep in mind that the ADA covers public and commercial spaces, so it doesn’t legally apply to most private homes. Still, it’s the best benchmark, and local building codes may have their own rules.
How to measure the rise
Rise is the vertical distance from the ground to the top of the doorway threshold or landing where the ramp will end. Measure it carefully, because every inch changes your length.
- Place a straight board or level across the top surface.
- Measure straight down to the ground at the spot where the ramp will begin.
- Take the measurement in inches, and measure in a couple of places if the ground slopes.
Then multiply the rise in inches by 12. That’s the ramp length in inches. Divide by 12 again to get feet.
Working through some examples
- A 4-inch rise needs roughly 4 feet of ramp.
- A 7-inch rise needs about 7 feet.
- A 12-inch rise needs about 12 feet.
- A 30-inch rise needs about 30 feet, which is where the next section matters.
If your rise is small, such as a single doorway threshold, a short ramp may be all you need. That’s where one of the foldable threshold wheelchair ramps can fit well. For a few steps, a longer portable ramp may be a better match, and our guide to portable wheelchair ramps for home steps shows the kinds available.
Landings and long ramps
Long ramps get broken into sections so the user can rest and turn. ADA guidance says a single ramp run shouldn’t climb more than 30 inches before a flat landing. A landing also goes at the top and bottom, and at any change of direction.
Landings should be at least as wide as the ramp, and at least 60 inches long, which gives room to stop or turn a wheelchair. The top landing by the door needs space to open the door without rolling backward.
Width, edges and handrails
Length isn’t the only detail. Plan for these as well:
- Width: At least 36 inches of clear width between handrails or edges.
- Edge protection: A small curb or rail keeps wheels from slipping off the side.
- Handrails: Generally expected on both sides for ramps with a rise over 6 inches.
- Surface: Non-slip and drained, so rain and ice don’t create a hazard.
When space is tight
If a 1:12 ramp would run too far across your yard, you can add a turn at a landing, fold the ramp into an L or U shape, or look at a lift. Temporary and modular systems can adapt to different heights, and our overview of the best portable wheelchair ramps covers common options. For stairs rather than a ramp, our straight stair lift guide explains a different solution.
Check the surface and the approach
A ramp isn’t only a slope. Check that the ground at the bottom is level and firm, and that there’s room to approach the ramp straight on. A turn right at the base makes it hard to build speed or keep control.
Think about weather as well. Rain and ice make smooth surfaces slippery, so choose a textured, non-slip finish and keep leaves and snow cleared. Test the finished ramp with the user and a helper before everyday use, and adjust anything that feels awkward.
Frequently asked questions
How long should a wheelchair ramp be for a 6-inch step?
About 6 feet at a 1:12 slope. A little longer is even easier to climb.
Can a ramp be steeper than 1:12?
It’s best not to. Steeper means more effort and a higher risk of tipping, so stick with 1:12 or gentler, and ask an occupational therapist or qualified installer if your space makes that difficult.
Do I need a permit for a home ramp?
It depends on where you live and how big the ramp is. A quick call to your local building office will tell you what’s required.
The bottom line
To get the right wheelchair ramp length, measure the rise, multiply by 12 and add landings where needed. If you’re not sure, ask an occupational therapist or a qualified installer to check the plan before you build or buy.

